The application of the screw press has greatly improved everyone's work efficiency. Before applying the screw press, people should install it in proper steps and ways, so that the application can be trusted.

  1. When the screw press is installed, check early to check whether the specifications of the basic anchor bolt opening gear are in line with the specifications of the motor shaft. You can then install the installation equipment in the prefabricated component, and tighten the pointing part to fix the nut.

  2 After the machine and equipment are put into the basic, the support frame and the thick steel plate of the embedded parts are welded firmly after being in place.

  Screw press

  3. When the installation of the press is completed, rotate the reducer by hand to type in the motor oil, and check whether there are interventions and stagnation in the fitness parts, and whether the fitness exercise is convenient.

  4. Is it appropriate to switch the speed reducer (according to the arrow symbol) when plugged in for trial operation.

  5. Start the drive organization to make it fully loaded. After everything is normal, the funds can be put into production.

  The application fields of screw presses are universal, but at the time of application, we must pay attention to application safety and carry out production and manufacturing in appropriate steps and methods to prevent production safety accidents due to small mistakes.

  The screw press is suitable for the compression and drying of grid slag. During operation, there is no clogging of the sewage pump, and the amount of maintenance work is usually small. The screw gear of the press sends the raw material to the feed

  The pipeline is compressed, and the height and width ratio of the feed can be determined according to the customer. There is a water filter hole in the human body, which collects a stainless steel sink, and the squeezed water can be discharged according to the pipeline. In the feed area, press

  Washing system software is set up in the squeezing area and the backwater area to make it difficult for the discharged waste and dirt to be polluted again. It is generally used in conjunction with Geshan, Hanji machine and other machinery and equipment to implement linkage control.

  The screw press is widely used in the sewage treatment manufacturing industry, and the key is to solve the grid slag and dirt in the Geshan dry and wet separator.

  Principle

  The waste enters the press tube from the feed port. Under the effects of the squeeze screw and the raw material extrusion molding tube, it is compressed and dehydrated and then transported to the hopper. The extruded wastewater is discharged into the  drain according to the outlet The screw press consists of a press tube, a press screw, a raw material extrusion molding tube, a pour, a stainless steel sink, a drain and a drive reducer.